[vox-tech] not sure what to call it

[Patrick Stockton]

using the hdparm tool i've turned off udma on both hda and hdb.

I'll wait to see if it happens again.

----- Original Message -----
From: "Patrick Stockton" <codejnki@codejnki.com>
To: <vox-tech@lists.lugod.org>
Sent: Saturday, April 13, 2002 1:49 PM
Subject: Re: [vox-tech] not sure what to call it


> Oh now this is an interesting idea, and HDB does happen to be a Maxtor
drive
> on the older side.  For as long as I've had this box HDB has been used as
> the linux partition used in a dual boot situation.  Now that i've got the
> laptop I put the system on HDA and on HDB I've got one large partition
that
> is mounted as /home
>
> I just ran a quick fdisk on hdb to see what it says and it gave me an
> interesting read out:
>
> Disk /dev/hdb: 255 heads, 63 sectors, 875 cylinders
> Units = cylinders of 16065 * 512 bytes
>
>    Device Boot    Start       End    Blocks   Id  System
> /dev/hdb1   *         1       876   7034296+  83  Linux
> Partition 1 does not end on cylinder boundary:
>      phys=(875, 186, 63) should be (875, 254, 63)
>
> I'm wondering what that exactly means...
>
> I looked for the /etc/sysconfig/harddisks but didn't find it.  Any other
> places I should look for DMA settings?  Possibly a jumper on the back?
> ----- Original Message -----
> From: "Samuel Merritt" <snmerritt@ucdavis.edu>
> To: <vox-tech@lists.lugod.org>
> Sent: Saturday, April 13, 2002 12:59 PM
> Subject: Re: [vox-tech] not sure what to call it
>
> I had a similar problem once; it turned out to be my cheap Maxtor hard
> drive that claimed to support DMA, but would hang every now and then.
> The symptoms were that the system seemed to be running okay, but any
> process that needed to use the disk for any reason (including being
> swapped in) would hang. CTRL+ALT+DEL wouldn't work because it would try to
> load /sbin/shutdown from disk, and hang. Also, the disk activity LED on
> the front of my case was on solid when this happened.
>
> If the symptoms persist, try disabling DMA on your hard disk(s) and see if
> the crashes end. Mandrake uses /etc/sysconfig/harddisks for IDE disk
> parameters.
>
>
>
>
> _______________________________________________
> vox-tech mailing list
> vox-tech@lists.lugod.org
> http://lists.lugod.org/mailman/listinfo/vox-tech
>