[vox-tech] Another Round of eth0 Problemas

[Karalius, Joseph]

Thanks for the correction Rick.

My Bad.  A big typo on my part.  'insmod 3c59x' produced a 'No such device'
error.  The card says Etherlink III on it and I took it to be a 3com, but
dmesg lists the device as 'ADMtek Comet rev 17'.  The driver is apparently
'tulip' and was loaded dynamically.  Nonetheless, I'm still having the same
problems.


> -----Original Message-----
> From: vox-tech-bounces at lists.lugod.org
> [mailto:vox-tech-bounces at lists.lugod.org]On Behalf Of Rick Moen
> Sent: Wednesday, March 02, 2005 10:57 AM
> To: vox-tech at lists.lugod.org
> Subject: Re: [vox-tech] Another Round of eth0 Problemas
> 
> 
> Quoting Karalius, Joseph (Joseph.Karalius at seminis.com):
> 
> > OK. I installed a working NIC from another box (it is a 10/100 so I
> > insmodded 3c509 to get it going)...
>             ^^^^^
> 
> This may have been just a typo on your part, but I frequently 
> see confusion 
> between two classes of 3Com cards:
> 
> 3C509 family:  ISA (long discontinued, but very good in its 
> day), 10 Mbps only
> 3C905 family:  PCI, 10/100 Mbps
> 
> -- 
> Cheers,                                      Hardware:  The 
> part you kick.
> Rick Moen                                    Software:  The 
> part you boot.
> rick at linuxmafia.com
> _______________________________________________
> vox-tech mailing list
> vox-tech at lists.lugod.org
> http://lists.lugod.org/mailman/listinfo/vox-tech
>