[vox-tech] suse 9.1: volume settings

[Kevin Murakoshi]

Out of curiosity, you're sure that the soundcard modules/ALSA
subsystem are starting up at boot? What could be happening is that the
machine boots but there are no sound drives, so YAST loads them when
it adjusts volume?

--kevin

On Tue, 24 Aug 2004 19:52:35 -0700 (PDT), Dylan Beaudette
<dylan at iici.no-ip.org> wrote:
> hi everyone,
> 
> recently installed suse 9.1 on the GF's computer and most things seem to
> be working properly (except for DVD playback, which i am still messing
> around with)... however there is one small quirk that i can't quite figure
> out.
> 
> when the machine boots there is no audio output from the machine, even
> though the volume and mixer settings are all set properly.
> 
> the only way to get audio output is to adjust the audio levels from within
> YAST (any change in volume will result in proper audio output)... after
> messing with the volumes for the sound card in YAST the audio output is
> fine until a hard reboot...
> 
> i am stumped...
> 
> Dylan
> _______________________________________________
> vox-tech mailing list
> vox-tech at lists.lugod.org
> http://lists.lugod.org/mailman/listinfo/vox-tech
>