[vox-tech] usb camera in RH 8.0

[Dick McCabe Jr]

On Thu, Jan 02, 2003 at 05:58:53AM -0800, Dick McCabe Jr wrote:
> After I switched from Mandrake 9.0 to Rh 8.0 I could no longer access
my
> USB camera.  This is where I am so far.  But I don't know where to go
> from here.
>=20
>=20
> [root@localhost log]# cat /proc/scsi/scsi
> Attached devices:
> Host: scsi0 Channel: 00 Id: 00 Lun: 00
>   Vendor: SAMSUNG  Model: CD-R/RW SW-408B  Rev: BS02
>   Type:   CD-ROM                           ANSI SCSI revision: 02
> Host: scsi1 Channel: 00 Id: 00 Lun: 00
>   Vendor: OLYMPUS  Model: C-120/D-380      Rev: 1.00
>   Type:   Direct-Access                    ANSI SCSI revision: 02
> [root@localhost log]# cd /
> [root@localhost /]# mkdir /mycamera
> [root@localhost /]# mount -t vfat /dev/sdb1 /mycamera
> mount: /dev/sdb1 is not a valid block device

Dick: could you please run the following command and pass along the
output:

        dmesg | grep -A 5 -B 5 'sd[a-e]' > scsi.log

The output will appear in the file 'scsi.log' (or what ever name you
choose
instead). The dmesg command repays the kernel boot log, and grep will
scan
for information on SCSI disks recognized by the kernel.

Here is the output: ( The first time I had the camera unplugged)

 Vendor: OLYMPUS   Model: C-120/D-380       Rev: 1.00
  Type:   Direct-Access                      ANSI SCSI revision: 02
WARNING: USB Mass Storage data integrity not assured
USB Mass Storage device found at 2
USB Mass Storage support registered.
Attached scsi removable disk sda at scsi1, channel 0, id 0, lun 0
SCSI device sda: 128000 512-byte hdwr sectors (66 MB)
sda: Write Protect is off
 sda: sda1
usb.c: USB disconnect on device 2
hub.c: USB new device connect on bus1/1, assigned device number 3
WARNING: USB Mass Storage data integrity not assured
USB Mass Storage device found at 3

Thanks for the help

Dick