[vox-tech] Soundcard/Modem conflict: Results of Mike's May 5th instructions

[Gregory Weber]

I'm the newbie with a soundcard/modem conflict that I emailed the list about
on Sunday, May 5th.

Mike then responded:

>   Run the following (which are read-only commands and will not fix
things),
and email the results to list.

=============
for l in /dev/ttyS*; do setserial -a $l; done

grep -vE '^#|^$' /etc/isapnp.conf

cat /proc/isapnp

ls -l /etc/rc.boot
ls -l /etc/isapnp.conf
=============

Here are the results:

1.  for l in /dev/ttyS*; do setserial -a $l; done

This produced screen-after-screen of information that I was unable to slow
down & capture.

I manually ran setserial -a on /dev/ttyS0 - 9.  Here're the results for 0-4

S0: Line 0, UART16550A, Port 0x03f8, IRQ:4
	Baud-base: 115200, close_delay: 50; divisor: 0
	closing_wait: 3000
	Flags: spd_normal skip-test

S1:  Line 1, UART16550A, Port 0x02f8, IRQ:3
	[otherwise same info as for S0]

S2:  Line 2, UART Unknown, Port 0x03f8, IRQ:4
	Baud-base: 115200, close_delay: 50; divisor: 0
	closing_wait: 3000
	Flags: spd_normal skip-test

S3: Line 3, UART Unknown, Port 0x02f8, IRQ:3
	Baud-base: 115200, close_delay: 50; divisor: 0
	closing_wait: 3000
	Flags: spd_normal

S4: Line 4, UART Unknown, Port 0x01a0, IRQ:2
	Baud-base: 115200, close_delay: 50; divisor: 0
	closing_wait: 3000
	Flags: spd_normal Fourpart


2. grep -vE '^#|^$' /etc/isapnp.conf

Lots more info; this one at least I was able to capture with |more.

But is there some way to pipe this to a file or my printer so that I don't
have to write it down manually and rekey it????

(READPORT 0x0273)
(ISOLATE PRESSURE)
(IDENTIFY *)
(VERBOSITY 2)
(CONFLICT (IO FATAL) (IRQ FATAL) (DMA FATAL) (MEM FATAL) # OR WARNING
(CONFIGURE ENS4080/19114957 (LD0
(IO 0 (BASE 0x330))
(IO 1 (BASE 0x530))
(INT 0 (IRQ 5 (MODE +E)))
(INT 1 (IRQ 9 (MODE +E)))
(DMA 0 (CHANNEL 1))
(DMA 1 (CHANNEL 0))
(NAME "ENS4080/19114957[0]{ENSONIQ SoundscapeVIVO}")
	(ACT Y)
))
(CONFIGURE ENS4080/19114957 (LD1
	(IO 0 (SIZE 8) (BASE 0x0200))
	(NAME "ENS4080/19114957[0]{ENSONIQ SoundscapeVIVO}")
(CONFIGURE USR0101/1388330562 (LD0
	(IO 0 (SIZE 8) (BASE 0x02F8))
	(INT 0 (IRQ3) (MODE +E)))
	(NAME "USR0101/1388330562[0]{USRobotics Courier V.Everything}")
	(ACT 7)
))
(WAITFORKEY)


3. cat /proc/isapnp

No such file or directory.

4. ls -l /etc/rc.boot

No such file or directory.

5. ls -l /etc/isapnp.conf
-rw-r--r--     /root    root     12363   April 21, 16:59  /etc/isapnp.conf


By the way, I can communicate with my modem. I sent the string "ATDT" with a
phone number to dial.  The ATDT woke the modem up, although it wouldn't dial
the number I'd instructed.


I look forward to further responses.